1、不能用煤油、酒精或是其它腐蝕性液體，以防液壓器元件、油箱等部件受到腐蝕，影響液壓器的正常使用。
1. Kerosene, alcohol, or other corrosive liquids cannot be used to prevent corrosion of hydraulic components, fuel tanks, and other components, which may affect the normal use of the hydraulic system.
2、清洗氣體增壓系統時，液壓泵運轉和清洗介質加熱應同時進行。因為，清洗油液的溫度為五十攝氏度到八十攝氏度時，系統內的橡膠渣時很容易被除掉的。
2. When cleaning the gas boosting system, the operation of the hydraulic pump and the heating of the cleaning medium should be carried out simultaneously. Because when the temperature of the cleaning oil is between 50 ° C and 80 ° C, the rubber residue in the system is easily removed.
3、液壓泵工作的時候進行間歇性的運轉可以提高清洗效果。
3. Intermittent operation of the hydraulic pump during operation can improve the cleaning effect.
4、我們應該在氣體增壓系統的清洗油路的回路上安裝過濾器，這樣可以過濾掉系統內大部分的雜質。
4. We should install filters on the cleaning oil circuit of the gas boosting system, which can filter out most of the impurities in the system.
5、清洗液壓泵的時間一般在四十八小時到六十小時之間，這是由系統的復雜程度和污染程度等因素決定的。
5. The cleaning time of hydraulic pumps is generally between 48 to 60 hours, which is determined by factors such as the complexity and pollution level of the system.
6、清洗結束時，不要立即使液壓泵停止運轉，應該使其持續運轉直到液壓泵氣溫恢復正常，這樣可以防止外界濕氣使內部器件生銹。
6. At the end of cleaning, do not immediately stop the hydraulic pump from running. It should be kept running until the temperature of the hydraulic pump returns to normal, which can prevent external moisture from rusting internal components.
7、清洗完氣體增壓系統后要及時把回路內的清洗油去除干凈。
7. After cleaning the gas boosting system, the cleaning oil in the circuit should be promptly removed.
為了延長氣體增壓系統的使用壽命，以后再清洗時請一定要注意上面說的這些方面。
In order to extend the service life of the gas boosting system, please pay attention to these aspects mentioned above when cleaning in the future.
This article is dedicated to the friendship of gas booster pumps. For more relevant knowledge, please click on: http://www.margilowry.com Sincere attitude. We will provide you with comprehensive services. We will gradually contribute more relevant knowledge to everyone. Stay tuned
