使用方要準備好被增壓的氣體和管路，驅動氣體和管路，高壓氣體的出口管路，按增壓泵出廠時所帶的說明先固定好增壓泵，按照增壓泵的各個進出口接頭尺寸，連接好管路；檢查是否耐壓足夠，接頭是否有泄露等，檢查完好后就可以進行增壓測試了。
The user should prepare the pressurized gas and pipeline, the driving gas and pipeline, and the outlet pipeline of high-pressure gas. Fix the booster pump according to the instructions provided at the factory, and connect the pipeline according to the size of each inlet and outlet joint of the booster pump; Check if the pressure resistance is sufficient, and if there are any leaks in the joints. After the inspection is complete, the pressurization test can be carried out.
氣源方面：氣體增壓泵的驅動氣源壓力范圍一般是在1.8-8bar，不建議它的驅動氣源超過10bar，如果驅動氣源過高，那么很大程度上會對泵體造成損傷，更有甚者會對操作人員造成傷害。
In terms of gas source: The driving gas source pressure range of gas booster pumps is generally 1.8-8bar, and it is not recommended to exceed 10bar. If the driving gas source is too high, it will greatly damage the pump body, and even cause harm to operators.
氣體增壓泵選型方面：客戶要根據自身需求的壓力選擇對應的增壓比，按照客戶自己的壓力需求，突出氣源壓力、進氣壓力、輸出壓力需求、流量是多少，這樣技術人員才能更準確的幫您選型。
In terms of gas booster pump selection: Customers should choose the corresponding boost ratio based on their own pressure needs, with a focus on highlighting the gas source pressure, intake pressure, output pressure demand, and flow rate according to their own pressure needs, so that technical personnel can more accurately help you select the type.
對現場使用環境方面：現場使用環境一定要干凈，不能有太大的粉塵顆粒，驅動氣源及被增壓介質水分不要含量太多，否則會大大降低泵的使用的壽命。
In terms of on-site usage environment: The on-site usage environment must be clean and free of large dust particles. The driving air source and pressurized medium should not have too much moisture content, otherwise it will greatly reduce the service life of the pump.
對管路的要求：客戶現場使用的時候一定要檢測高壓輸出管道的密封嚴實性，采用的管道、閥門、壓力表一定要大于氣體增壓泵輸出的額定壓力，限度的保證人員的操作安全。
Requirements for pipelines: When customers use them on site, they must check the sealing tightness of the high-pressure output pipeline. The pipelines, valves, and pressure gauges used must be greater than the rated pressure output by the gas booster pump to ensure the maximum operational safety of personnel.
對壓力容器的要求：各部分承壓件，特別是壓力容器，一定要具有壓力安全容器廠家生產的壓力安全容器檢查報告。
Requirements for pressure vessels: All pressure parts, especially pressure vessels, must have a pressure safety vessel inspection report produced by the pressure safety vessel manufacturer.
This article is written by a gas booster pump. For more products and detailed exciting content, please follow our website: http://www.margilowry.com We will present more content for you.
